Company News

Performance characteristics:

1. Select frequency converter and frequency conversion motor, so that the chopping speed can be arbitrarily adjusted between 300-3000 rpm, the machine has low noise, high efficiency and significant energy-saving effect.

2. The chopping material is processed by special technology, and the chopping pot is cast all stainless steel, and there is an anti-overflow pot edge to prevent seepage and overflow.

3. The chopping pot is two-speed, which can be combined with any speed of chopping, the cutting time is short, and the temperature rise of the material is small.

4. Equipped with discharger, convenient and clean discharge. 

5. The electrical parts adopt waterproof design, good sealing and easy cleaning.

Operational considerations:

1. Turn on the power supply (pay attention to the ground, the total switch is a circuit breaker of 100A), press the discharge handle, at this time, from the direction of the handle, the discharge tray should be turned clockwise. Otherwise, swap any two phases of the power supply. 

2. Check the position of the lid of the pot, that is, there is no debris in the pot. 

3. Press the D low-speed button, and the chopping D should rotate towards the front of the machine. 

4. Press the start button of the rotary pot, and the direction of turning the pot is counterclockwise. 

5. The above can determine the correct direction of each running motor. Then start the rotation according to the required speed, turn the pot, and add materials to the pot in batches. Generally, it is the principle of medium speed first and then high speed. dLow speed operation is only used when mixing powder. 

6. After chopping and mixing, press the discharge button, and slowly press the discharge handle to realize batch discharge. The discharge handle is raised to stop the discharge. 

7. When the action is over, turn off the power, clean up the pot and equipment hygiene.